Hi!
Lenne ez a rádió:
https://classicboombox.com/toshiba-rt-sf5
Eléggé nehezen, recsegősen jönnek az adók, (értelem szerűen minél nagyobb térerejű az adó, annál jobb a vétel, de így is sz@r... ) Az FM zaj is inkább FM recsegés....
Mit lehetne vele csinálni?
Kösz
Hello.
here is a message to share my experience in solving a problem that appeared on the home-cinema amplifier ONKYO tx-DS494.
In order to sell this amplifier I had to check if all the outputs and all the functions works properly.
On the back of this amplifier you have to frontal output : A and B.
I connect a pair of speaker on A output : no problem. I can adjust volume.
when i connect the pair to the b output and turn the volume knob no sound came out of the speakers until I reach a level defined by I don't know what. :hmmm: My volume level goes from 0 to 80db ( if I remember well ). from 0 to 23 db no sound and when I reach 24 dn sound increase and stabilize.
With hearphone connected, i don' have this problem so I conculde that amplifing transistor could not be incriminated.
I checked on the service manual and saw that there are two or three component that could be the source of the problem : the main processor, some capacitors on the output PCB and relays.
I began testing capacitors: no pb. then I thought that if cannot be the main proc because it ( I think ) works in a binary mode: it works or it doesn't. so I decided to switch between themselves the two relay and :super: : it works. The relays was in fault and did not switches properly.
here is my experience in repairing an amplifier
Sziasztok! Adott egy Denon AVR-1311 erősítő. Úgy került hozzám, hogy tiltott a védelem, nem indult el. Gyorsan meglett a hiba. Az egyik csatornán C-E között zárlatos volt mind a 2db végtranyó, valamint a 2-2 párhuzamosan kötött emitter ellenállásból az egyik pár szakadt volt, illetve még zárlatos volt 1db 3,3V-os zéner dióda. Ezek cseréje után tökéletesen működött kb 1 hétig, majd megint ugyan ez a hibajelenség és ugyan ezek az alkatrészek rosszak. Mellékelem a rajzot, igaz telefonnal fotóztam, de talán látszik a lényeg. Q464, Q466, R517, R518 és ZD51 poziciójú alkatrészekről van szó. Kérdés mi lehet az oka, hogy újra bekrepált? Én a végtranyókra tippelek, mert eredeti Shankent nem kaptam csak PMC-t. Ha ez a gond mit érdemes beletenni helyette, mert nem szeretném újra szétszedni és kínlódni vele?
Sziasztok! esetleg ha valakinek lenne a fent említett erősítőhöz jó állapotú, távirányító eladó azt kérném jelezzen vagy dobjon egy privátot! Zsolt