Se trata de fallo localizado en placa E1205777-005 los elementos c1041 c1042 c1043 c1044 de valor 47 mF 25V los cuatro en mal estado y IC 612 e IC611 corroidos por acido de los condensadores electroliticos, me es imposible leer los valores de los mismos ; Y en el diagrama no figura la placa del receptor RX- 1010 JVC. Codigo placa según diagrama
E 12057-005
Alguien podria por favor ayudar a localizar los valores de estos transistores.
Sziasztok
Kaptam ajándékbe egy ilyen minidisc lejátszó felvevőt ismerösömtől de olyan próbléma volt vele hogy eléggé halovány volt a kijelzője megnéztem és látom ilyen VDC kijelző van benne gondolom megövelem a fütési feszültséget és jó lesz egy darabig . Amikor megakartam mérni hirtelen eltünt minden kijelzés de érdekes modon továbra is füti a csövet mert 5.5Volt van rajta de nam akar müködni nem tudom valaki esetleg tatékozott e ilyen problémával? vagy a müszerem valamit tönkre tett benne ? szóval tanácstalan vagyok .
sziasztok!
Van egy fent nevezett HiFi készülék aminek nem müködik a kazetta része.Ez a rész nem is kellene de ha kikötöm az A és a B kazettarészhez menő szalagkábelt akkor is megjelenik a kijelzőn hogy a B kazettaegység lejátszáson van. Ha átkapcsolom Tunerra vagy CD-re akkor meg nem ad ki hangot.AUX-ra kapcsolva is ugyanez a helyzet.Lehetséges az hogy a kazettarészt figyeli a központi CPU és emiatt nem müködik rendesen?
Előre is köszönöm a segítségeket, hozzászólásokat.
üdv: Tiva
Given:
Victor TT-71, neon lamp does not light, speed is lower than normal. This is subsequent some short circuit the owner does inside the device. No further details.
I found out the VICTOR QL7 have the same motor driver amd I downloaded the service manual that I attached here in case this manual is not already uploaded.
Looking at the diagrams I found out that at TP3 (same with pin5 of IC803) instead if that rectangular signal, I have nothing but 5VDC and a negative or positive short spike whenever I'm starting or stopping the motor and
Under the circumstances I suspect IC803 is defective. The bad thing, IC803 is NPC SC8043. Also I wonder if the crystal is fine (except that I wonder what can be wrong with a crystal after some short circuit).
Does anybody have any more suggestion?
Also, where can NPC SC4043 be sourced? Also, a crystal 9.054MHz?
Thanks in advance,
Corneliu