Hello,
Last week I picked up a nice Kenwood KA-3500 40watt intergrated amplifier in pretty good shape.
Upon using it a bit more, I noticed a bit of distortion at high volume, more so in the left channel. I checked the DC offset at the speaker terminals, and the L channel said 100 mV, while the R was 25 mV. I understand this isn't so good for the L channel at least, but unfortunately this amp doesn't have any DC offset adjustments. Am I right in saying that to fix this I'd have to replace the output transistors?
--
On a related issue, in the service manual I found the section on BIAS adjustment, and I read online how it can affect the DC offset. So I hooked up my voltmeter to the test points, and I got 4 mV on the L, and 8 mV on the R. In the manual it says should be 40 mV.....(!). Is there something wrong here? I tried carefully adjusting them, but they only go to 30mV with the pots fully on, this doesn't seem right to me.
--
I compromised at 20 mV BIAS for both channels, and now the DC offset is 50 mV for L, and 5 mV for R, which is better, less than half what they were. I'm wondering, will I damage anything doing this, should I put them back to where they were?
--
The service manual is on site here.
Let me know if you want me to upload an english copy of the Owner's Manual, it has a better schematic in it all on one page, easier to read.
I've also included some pictures. They're not my actual unit, but mine is exactly the same, but less dusty.
--
Thanks for reading this. Many thanks in advance, and have a peaceful Palm Sunday! :taps2:
Bellarmine
Sziasztok.
A fenti autórádióval van gondom.
A hibajelenség:
tuner üzemmódban nem szól a rádió( még zaj sincs), nem lehet hangolni, nem reagál a két hangoló gombra(<< >>).
Próbáltam átállitani a menüben manual-ra, de akkor sem reagál a gombokra.
A többi gomb(FM,AM, programgombok, stb...) tökéletesen müködik.
Ha a menüből akarnám az automata hangolást elinditani, arra sem reagál.
A két hangológomb egyéb üzemben tökéletesen teszi a dolgát.
Nincs belepiszkálva, nem volt még megbontva sosem..
Mi lehet a gond???
Köszönöm.
Sziasztok!
van egy kenwood ka-74 erősítőm és az érdekesség, hogy kb 1 hónapja használtam nem volt agyon hajtva szépen szolt 1 hónapon keresztül nem volt bekapcsolva és most nem szól kivéve ha phono-ra kapcsolom és kb feltekerem 7esig a hangerőt akkor egy pillanatra el kezd ordítani és ennyi.Kimeneten zárlat nincs füllhallgatót bedugva sem szól viszont a phono-nál a füles is és a hangfalak is megnyekken egy pillanatra.
Van benne egy protection áramkör relé nincs nem tudom az tiltana e. Nincs valakinek valami ötlete?
Kapcsi rajzot nem találtam
Sziasztok!
Az lenne a kérdésem,hogy a fent nevezett erősítőben kellene cserèljem a hangszínszabályozó encodert!
A gyártója az meg van ALPS gyártmány,csak a pontos tipusát nem találom még a rajzon sem!
Ha valaki tudja legyen szíves írja le!
Előre is köszönöm!