Kérem, guriga és Guest ne szóljon a topichoz!
Sziasztok!
Tudnátok segíteni?
Lenne ez a gép. Random módon elmegy a kép, visszajön, elmegy stb. majd
kikapcsol, és 8-at villog a stby led. Csak áramtalanítás után
kapcsolható vissza .
Ez a fajta SS van benne. A csatiakat átnéztem, a földelő csavarokat megtéptem.
Ezeket végigcsináltam amit ír a 8 hibára.
www.werbemousepads.de/pdf/2012_Plasma_TV_Troubleshooting_Guide_2012_04_16_revised.pdf
Van valakinek más ötlete esetleg?
Kösz
Sziasztok!
Most alakítottam át a függőleges eltérítést, TDA8175-ről TDA8172-re, csak be kellene állítani a méretet és a helyzetet, mert kicsi a kép. Kell hozzá az eredeti táv?
Manufacturer: Panasonic
Type: TX-L42ETW5
Chassi: LA35
Hello everybody,
I could determine or measure the following with the device:
Device does not start anymore, stand-by LED lights red when device is plugged in and flashes red as soon as an IR command (key press) is sent via the remote control. Voltages of power supply STB 5V and signal LCD_TV_SUB_ON come from A-board. Power supply starts, supplies P15V and SUB1.1V, 1.5V, 1.8V, 3.3V, 5V, HDMI3.3V and USB5V are generated on the A-Board (stand for about 2.5 seconds). Then signal LCD_TV_SUB_ON goes low (voltages go away to STB 5V) and after about 2 seconds back to high (endless). What is missing is the voltage PNL12V which is switched on by PANEL_VCC_ON2. PANEL_VCC_ON2 always has a low signal and does not change its state. Power supply also provides for the 2.5 seconds the 24V for the backlight. Clocking of LCD_TV_SUB_ON starts immediately after plugging in the mains plug (also without IR command). SOS error code is not output. The over-voltage circuit in IC 5000 pin 7 also does not respond. Attached is the timing diagram from the technical training of Panasonic where I have drawn until when the boot process behaves normally.
In my opinion a mistake on the A-board? Does anyone have a tip?
greetings
Andi
Sziasztok!
Egy barátom fordult hozzám az alábbi kérdéssel. A fenti LCD TV képe zajos. Próbálta RCA bemenetről és SCART bemenetről is (de csak kompozit jellel mert RGB nem állt rendelkezésre). A menü/OSD nem zajos. Átkondizta a tápot, de a helyzet nem változott. Csatolok képet a hibáról. Mi a véleményetek, merre keresgéljen?
A tuner-ről nem tudta kipróbálni mert analóg tuneres.
Üdv.